Periodic Maintenance General Information - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL
Section 7: Periodic Maintenance General Information
Important
Only qualified service personnel should service the PROCESSOR.
Note
• This section includes additional procedures that are not in the Operator Manual, Publication Number 981089.
For details about daily and weekly maintenance, see the Operator Manual.
• To ensure optimum operation of the PROCESSOR, it is important to use the following procedures.
[1] Process 5 sheets of unprocessed film of varying exposure before you begin the preventive maintenance. Check
for artifacts on the film.
[2] Follow the recommended preventive maintenance procedures outlined in Table 3 on Page 101.
[3] Check the PROCESSOR for:
• cleanliness
• broken parts
• wear of parts
• leakage
• adherence to site specifications
[4] Remove any parts that are broken or have wear, and install new parts.
Warning
Dangerous Voltage
• Disconnect the main power before lubricating the parts.
• Do not allow any oil or grease to touch the RACK ASSEMBLIES or to drip into the TANKS.
• Use only recommended materials for the cleaning and lubrication of parts.
[5] Use the correct procedure to clean the parts.
[6] Make the necessary adjustments.
[7] Provide lubrication, if necessary. See Table 3 on Page 101.
[8] Process 5 sheets of unprocessed film of varying exposure in the PROCESSOR after you have done any service
procedures. Check for artifacts on the film.
100 September 1995 – 981090