Removing The Developer/Fixer Replenishment Pump (B3) - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL

Removing the DEVELOPER/FIXER REPLENISHMENT PUMP (B3)

Removing the REPLENISHMENT
Figure 48
PUMP
HOSE CLAMP
TL-2170
WIRE
TIES
SCREW
(2)
WASHER (2)
LOCK WASHER (2)
58
HOSE (4)
REPLENISHMENT
PUMP
CONNECTOR
P/J7
H130_0028CCA
H130_0028CA
[1] Disconnect CONNECTOR P/J7.
[2] Remove the following parts from the front and
back of the REPLENISHMENT PUMP base:
• 2 SCREWS
• 2 LOCK WASHERS
• 2 WASHERS
[3] Install 4 CLAMPS TL-2170 on the 4 HOSES
attached to the REPLENISHMENT PUMP to
prevent the leakage of developer and fixer
solutions when you remove the HOSES from the
REPLENISHMENT PUMP.
[4] Identify the REPLENISHMENT HOSES.
• The developer REPLENISHMENT HOSE
can be identified by a red WIRE TIE.
• The fixer REPLENISHMENT HOSE can be
identified by a blue WIRE TIE.
[5] Cut and leave in position the WIRE TIES securing
the 4 HOSES to the REPLENISHMENT PUMP.
[6] Remove the HOSES from the
REPLENISHMENT PUMP.
September 1995 – 981090