Suzuki SY413 Service Manual page 2863

6A1-34 ENGINE MECHANICAL (G13/G16 TYPE ENGINE)
1. Rocker arm spring
1. Parallel
INSTALLATION
1) Apply engine oil to rocker arm shaft and rocker arms.
2) Install rocker arm shaft, rocker arm (exhaust side) and rocker
arm spring.
2. Rocker arm (EX)
3) Check O-ring for damage or deterioration. With O-ring groove
1. Rocker arm shaft
2. O-ring
in rocker arm shaft exposed to transmission side once, Install
O-ring to rocker arm shaft.
4) Set rocker arm shaft so that its cut part faces down and be-
comes in parallel with head cover mating surface.
5) Install rocker arm shaft bolts and tighten them to specified
torque.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
6) Fill small amount of engine oil into arm pivot holding part of rock-
er arm shaft. Install rocker arm (intake side) with clips to rocker
arm shaft.
1. Rocker arm
2. Clip
3. Pivot holding part