Subaru IMPREZA GD 2007 Series Manual page 1379

asieps_tobira_IM_US.book 48 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Clear Memory Mode
ENGINE (DIAGNOSTICS)
13.Clear Memory Mode
A: OPERATION
1. SUBARU SELECT MONITOR (NORMAL
MODE)
1) On the «Main Menu» display screen, select
{Each System Check}.
2) On the «System Selection Menu» display
screen, select {Engine Control System}.
3) Select the [OK] after the information of engine
type has been displayed.
4) On the «Engine Diagnosis» display screen, se-
lect {Clear Memory}.
5) When the «Done» is shown on the display
screen, turn the ignition switch to OFF, and then
Subaru Select Monitor to OFF.
NOTE:
For detailed operation procedure, refer to the
"SUBARU SELECT MONITOR OPERATION MAN-
UAL".
2. SUBARU SELECT MONITOR (OBD
MODE)
1) On the «Main Menu» display screen, select
{Each System Check}.
2) On the «System Selection Menu» display
screen, select {Engine Control System}.
3) Select the [OK] after the information of engine
type has been displayed.
4) On the «Engine Diagnosis» display screen, se-
lect {OBD System}.
5) On the «OBD Menu» display screen, select
{DTC Clear}.
6) When the «Clear Diagnostic Code?» is shown
on the screen, press the [OK].
7) Turn the ignition switch to OFF and then close
the Subaru Select Monitor.
NOTE:
For detailed operation procedure, refer to the
"SUBARU SELECT MONITOR OPERATION MAN-
UAL".
3. GENERAL SCAN TOOL
For procedures clearing memory using the general
scan tool, refer to the general scan tool operation
manual.
EN(STI)(diag)-48