Table of Contents
Advertisement
Chapter 4 Using the On-Screen Display Interface
Specifying Channel Names
Default channel names for active channels are 'PC'. You have to assign unique channel names
to identify each connected server.
Note that channel names are stored on each cable connected to the 1754-A1T. Therefore, you
can only rename an "active" channel where a "powered" 1754-A1T is available. Besides, the
channel name will disappear or be moved to another port if you move the 1754-A1T to a
different port.
Changing channel names
1. If the OSD is not displayed, press the hot key 3 times.
The default hot key is 'Scroll Lock.' To change it, see
2. On the Selection Menu, select an active channel and press F3.
If the desired channel is not shown on the current page, press Page Up or Page Down.
3. The RENAME page displays. Type a name up to 14 characters.
4. Press Enter to save the new name, or Esc to cancel it. 5. Repeat the same steps for
additional channels.
5. Repeat the same steps for additional channels.
20
System Settings
ThinkSystem Analog 1x8 KVM Switch User Guide
on
page
24.
Advertisement
Table of Contents
