Figure 31 Signal Period Set Up Options; Table 11 Output Signal Period For Programmable Output - Panasonic Firetracker FT1020G3 CIE Technical And Programming Manual

Delay time, Pulse length, Pulse off and/or De-Activation, have to be set for the "Signal
period" respectively. For types 2 & 5 the x and y times must be equal and maximum 5.6s.
For types 3 & 6 the x time must be maximum 5.6s.
Note: The different types can be used together with the different outputs according to the
following Table 11 below

Table 11 Output signal period for programmable output

Output
Type
1 Steady (continuous)
2 Intermittent
3 One pulse
4 Steady (continuous),
delayed activation
5 Intermittent,
delayed activation
6 One pulse,
delayed activation
7 Steady (continuous),
delayed de-activation

Figure 31 Signal period set up options

In FT1020G3
S0- R0, 4581 4583
S3 R1 board board
X X X X
X X XXX --
X X XXX --
X X X X
X X XXX --
X X XXX --
X X X X
85
Technical/Programming Manual
COM loop units
I/O Unit Siren, S/B &
unit 3364 Beacon
3361 4477, 3379,
4383 & 4380
X X X
-- XX --
-- -- --
X X X
-- XX --
-- -- --
X X X
FT1020G3 Rev 2.2.1
4582 Inter
board locking
X X
-- --
-- --
X X
-- --
-- --
X --