Control Unit Outputs S0 - S3; Figure 29 Eblwin 3379 And 4477 Dialog Boxes - Panasonic Firetracker FT1020G3 CIE Technical And Programming Manual

For each priority level:
 Sound type (different for each priority level)
 Name
 Type (Normally "Alarm device")
 Output signal period (Normally "Steady")
 Control expression (with one or more trigger conditions)
If "Enter arguments in dialog" is selected, a separate dialog box is opened for easier
entering of the required data (e.g. zone, address, etc.).
Output test
When a PC is connected to a Control Unit, EBLWin open and you are logged on, each
output can be tested for activation / de-activation.
Control Unit outputs S0 – S3
12.1
FT1020G3 Control Unit has four programmable, supervised (monitored)
S0
S1
S2
83
S3
Connections and more information, see drawing F732-02.
82
This is default, but via EBLWin it is possible to set each output individually as not supervised (not monitored). A normally high
output is non supervised. See also chapter "Calibration of supervised outputs", page 122.
83
Note! This output will be low in case of system fault (via the watch dog reset circuit). May be used as a supervised voltage
output for fault warning routing equipment (Fault TX).

Figure 29 EBLWin 3379 and 4477 dialog boxes

Supervised voltage output, 24V
Supervised voltage output, 24V
Supervised voltage output, 24V
Supervised voltage output, 24V
80
Technical/Programming Manual
FT1020G3 Rev 2.2.1
, max. 500 mA (Fuse F4)
DC
, max. 500 mA (Fuse F5)
DC
, max. 500 mA (Fuse F6)
DC
, max. 500 mA (Fuse F7)
DC
82
voltage outputs: