Table of Contents
Advertisement
Technical/Programming Manual
FT1020G3 Rev 2.2.1
For each day, five time intervals can be programmed. A time interval can be edited by
dragging the whole interval (or the left / right side of it) to the left or right in the day field.
Alternatively, double click the time interval box in the day field to open a dialog box for
easier time editing:
Figure 52 Editing Time Channel Intervals
A time interval can be copied in one day field and pasted into another day field. Click in the
blue interval from a selected day, then use Ctrl+C (copy) then Ctrl+V (paste) into another
selected day.
All other days are programmed the same way.
National: Programmed the same way as the Monday. See also chapter "National
holidays", page 157.
Current day: The programmed time intervals (when the time channel is "on") for the
selected day, are shown here.
Cursor time: The cursor position (time) in the day field, is shown here.
Time channels 3 - 14 are programmed the same way as time channel 2.
22.3.3
Alarm algorithms
The following is not valid for the detectors 4400 and 4401 in Advanced mode. (See chapter
"Advanced mode", page 131).
In Normal mode 440x = 430x.
153
Advertisement
Table of Contents
