Table of Contents
Advertisement
Progress
bar
24.1.2
Download the Software
1. Set the Main board 5010 in "boot" mode, i.e. press and hold the "Boot" button
(SW2) then press the "RESET" button (SW1) momentarily. Release the "BOOT"
button. The Main board LED "D24" is turned off while the Main board is in "boot"
mode.
2. Start the download, i.e. click "Start".
Another dialog box opens.
3. Set the MMI board 5011 in "boot" mode, i.e. press and hold the "BOOT" button
(SW2) and press the "RESET" button (SW1) momentarily. Release the "BOOT"
button. The MMI board LED "D18" will be turned off and the buzzer is turned on
while the MMI board is in "boot" mode.
4. Click "OK", the buzzer is turned off and the download continues. The download
status is indicated by the progress bar.
5. When the progress bar goes from "red to green", the download will be completed
and the following dialog box opens:
6. Click "Yes" and the Control Unit will restart.
After the restart, the following messages will be shown:
FAULT: Restart control unit nn, code 00
DD-MM-YYYY HH:MM
166
Technical/Programming Manual
FT1020G3 Rev 2.2.1
Advertisement
Table of Contents
