Table of Contents
Advertisement
Suppress buzzer during fault from other Control Units: This check box should
be marked if faults generated in other Control Units to be suppressed in this Control
Unit, i.e. if the buzzer to be sound for faults generated in this Control Unit only.
Use Pre-warning: This check box is to be marked if the pre-warning detection is
required to be enabled, i.e. pre-warnings will be activated in this Control Unit and
presented in all Control Units. All programmable outputs in the system, with trigger
condition "Pre-warning", will be activated (if not disabled).
Checkbox not marked = Pre-warnings will not be activated in this Control Unit.
20.2
EBLWin Control Unit pop-up menu
Some commands are disabled since you have to connect and log on to the Control Unit to
be able to select / use them.
20.2.1
Reset alarm counter
The Control Unit has an alarm counter that can be reset if required. (Level 2, i.e. a special
access code is required).
20.2.2
Software version
The Control Unit software (S/W) version will be displayed.
20.2.3
Upgrade number of alarm points
The FT1020G3 is delivered with 510 addresses as default, it can be upgraded to 1020
addresses on request. The number of addresses can be upgraded to 1020 addresses
either in the factory when the purchase order is received or on site.
If the number of alarm points is required to be upgraded, a PC and EBLWin are used. The
PC has to be connected to the USB connector in the Control Unit and you have to be logged
on.
Technical/Programming Manual
139
FT1020G3 Rev 2.2.1
Advertisement
Table of Contents
