20
Control Unit Properties
In EBLWin, please note:
EBL512 G3 = FT1020G3
EBL128 = FT128
Figure 45 The EBLWin "Control Unit properties" dialog box
Note: Default settings in EBLWin might vary depending on convention.
20.1
Control Unit properties dialog box
Opens when you add a Control Unit or via the "Control Unit" pop-up menu (Properties...)
20.1.1
General Information
Control Unit number: A stand-alone Control Unit must have no. 0. In a system (TLON
Network) the Control Units are numbered from 0 to 29.
Name: Normally not changed but can be changed when required.
20.1.2
Peripherals
MMI board (default): This check box is to be marked when the CIE has a front
with display (i.e. standard FT1020G3).
This check box is not to be marked when the CIE. has no front
Printer (optional): This check box is to be marked when the CIE is fitted with a
printer.
20.1.3
Misc.
Configured number of alarm points: 512 or 1020.
Set the required number and the validation check in EBLWin can give a "too many
alarm points" warning. The validation check is automatically performed when
starting a download of SSD to the CIE.
Technical/Programming Manual
138
FT1020G3 Rev 2.2.1