Table of Contents
Advertisement
Figure 35 EBLWin "Interlocking Combination" dialog box.
To configure an interlocking combination, the following procedures can be used:
1
Select from each side of the interlocking inputs and/or outputs lists, click the
button, this puts the selection into the selected output/input fields.
2
Click the
reused elsewhere.
3
Click on the
4
To locate the device from which each input/output has been used, click on the
adjacent
button. The device dialog box will appear. This is a time saving
feature when you have close to hundred interlocks specified.
The configured interlocking combination should display the following:
Name: Displayed in the EBLWin Tree and List views. Default is "Interlocking
Combination" that can be edited when required. "Area-Point" will be added in the
tree view and shown in the list view.
Area and Point: Each "Interlocking Combination" is presented as Area-Point
(compare with Zone-Address). Area numbers 1-999 are possible to use and within
each area, Point numbers 1-99 can be used.
Note: An Area can only be used in one CIE.
Available interlocking outputs list displays all the previous programmed outputs,
Type = "Interlocking".
Available interlocking inputs list displays all the previous programmed inputs,
Type "Interlocking". Select one output and one Input. Press Select and the
selected output and input will be shown in the Selected output and Selected input
field respectively.
It is possible to Remove an output / input (from the field).
It is possible to Find (open the dialog box) an output / input.
Output parent: Shows where the selected output is situated, e.g. Control unit 0.
Input parent: Shows where the selected input is situated, e.g. Control unit 0.
button, the selections will disappear from the lists and cannot be
button beside the respective input/output to delete selections.
98
Technical/Programming Manual
FT1020G3 Rev 2.2.1
Advertisement
Table of Contents
