Interlocking Indications; Interlocking Outputs And Inputs (H9); Activated Interlocking Outputs / Inputs (H9/C1) - Panasonic Firetracker FT1020G3 CIE Technical And Programming Manual


Text = User definable interlocking text to be shown in menu H9/C1. Can be written
in this field or in the "Texts" dialog box, see chapter "Creating the alarm texts via
EBLWin", page 123.

Buzzer checked = activated interlocking input will turn on the FT1020G3 buzzer
(0.8 / 0.8 sec.)
again, if a new interlocking input is activated.

Latched output checked = Output reset has to be performed via menu H9/C3.
(Automatically output reset will not take place when the control expression
becomes false.).

Fault checked = Fault detection ON.

Fault Detection Time: If the input is not activated within 5-255 seconds
after the output is activated
15.2

Interlocking indications

One or more activated Interlocking Combinations (interlocking output and/or input) are
listed in the CIE display
Disabled interlocking output is indicated by the LED "Disablements".
15.3

Interlocking outputs and inputs (H9)

Menu H9 has the following sub menus.
15.3.1

Activated interlocking outputs / inputs (H9/C1)

The following information will be shown in menu H9/C1:
or
or
AAA = Interlocking combination Area
Priority order: Fire alarm – Pre-warning - Interlocking - Fault.
114
115
After the end of the delay time (if used).
116
This indication has the lowest priority and will only be shown if the display was empty.
114
. The buzzer can be silenced. It will be automatically turned on
115
, a fault will be generated:
FAULT: Interlocking input AAA/PP
116
:
Interlocking area AAA point PP output active
User definable text message..
dd-mm-yyyy hh:mm
Interlocking area AAA point PP input/output
active
User definable text message..
dd-mm-yyyy hh:mm
Interlocking area AAA point PP input active
User definable text message..
dd-mm-yyyy hh:mm
99
Technical/Programming Manual
FT1020G3 Rev 2.2.1