Web-Server - Panasonic Firetracker FT1020G3 CIE Technical And Programming Manual

Erase SSD...: (FT1020G3 must be in boot mode.) The SSD stored in an FT1020G3
Control Unit will be erased. Also the SSW (see Operation Manual) will be erased. NOTE:
An EBLWin key is required.
Reset user passwords...: (When connected and logged on to an FT1020G3.) If any
password has been changed via the Control Unit menu (H10) or via a Web-server, it will
be reset to the password downloaded via the SSD, i.e. the passwords in the EBLWin dialog
box "User data" (found in the menu "System").
Download Software...: (When connected and not logged on to an FT1020G3.) NOTE:
An EBLWin key 5094 is required. Opens a dialog box for download of an EBL512G3 S/W
file (xxx.bin) to an FT1020G3 Control Unit. (There is one .bin file for each convention).
Download EPU/AAU software: (When connected to a Display Unit – via RS232.) For
download of S/W (xxx.bin file) to one Display unit. NOTE: An EBLWin key 5094 is required.
Options...: EBLWin settings. A Convention (one for each country) is selected the very first
time EBLWin is opened. Can be changed if Level 2 is selected, see below. Display Unit
language can be selected as well as the EBLWin language.
Advanced Functions: Can be one of the following alternatives:

No "Level" selected (default): Alarm algorithm parameters cannot be changed.

"Level 1" selected: all Alarm algorithm parameters, except the fire alarm
parameters can be changed.

"Level 2" selected (a special password is required): Also the fire alarm algorithm
parameters can be changed. The convention for the opened installation can be
changed in "Options...".
Backup EBLWeb configuration: (When connected to the Web-server TCP/IP). Opens a
dialog box for backup of the Web-server configuration to EBLWin.
Download EBLWeb configuration: (When connected to the Web-server TCP/IP).
Download of the configuration to a Web-server. NOTE: An EBLWin key 5094 is required.
Download EBLWeb software: (When connected to a Web-server – TCP/IP). Download
of the software to a Web-server. NOTE: An EBLWin key 5094 is required.
22.5

Web-server

1. First create the SSD for the installation. In menu "System", select "User data" and
check (mark) the user names / passwords that have to be used with the Web-
server as well.
2. Add a Web-server to a Control Ubit (C.U. menu: Add Web-server ....)
3. Do the required Web-server configuration.
4. Download the Web-server Software (firmware) V2.2.x to the Web-server.
5. Download the Web-server configuration to the Web-server, "Include SSD Data"
must be marked.
6. Do a "power off – power on" Web-server restart.
Technical/Programming Manual
161
FT1020G3 Rev 2.2.1