Replacing The Carriage Filter - MIMAKI TS55-1800 Operation Manual

Replacing the Carriage filter

Replace the Carriage filter (PN:SPC-0844) when it gets
too dirty.
• The Carriage filter is an optional item. You can buy
one through your local dealer or from our service
office.
• When turning the main power switch off for moving
the machine or for solving the error or the like,
press the [END/POWER] key a long time on the
front of the machine, check the display is turned
off on the operation panel, and then turn the main
power switch off.
1
Turn OFF the power of the connected PC.
2
Turn the power off, by giving the
key a long press.
3
Turn off main power switch.
• Tilt the main power switch on the side of the unit
to "" side.
4
Open the front cover.
[END/POWER]
key
Main power
switch
Carriage
Chapter 4 Maintenance
5
Remove the Carriage filter.
6
Insert a new Carriage filter.
• Pay attention to the direction to install the Carriage
filter.
OK
7
Close the front cover.
8
Turn the main power switch ON.
(1) Set the main power switch located on the
side of this machine to the "I" side.
• When the power is turned on, the firmware
version is displayed and the initial operation
is executed.
(2) Press the [END / POWER] key to turn on the
power.
[END/POWER]
key
1
2
NG
2
4
5
Main power
switch
6
4-23