Check Conditions For Which Nozzle Recovery Cannot Be Performed; Set Whether To Enable Nozzle Recovery During Test Print - MIMAKI TS55-1800 Operation Manual

Check Conditions for Which Nozzle
Recovery Cannot be Performed
1
Press (MENU) in LOCAL.
2
Press to select
"MAINTENANCE", and press the
key.
• Maintenance menu will be displayed.
3
Press to select "NOZZLE
RECOVERY", and press the
4
Press to select "CHECK", and
press the
• Judgment Condition input screen will be
displayed.
Judgement Condition
Resolution
PASS
Scan Speed
MAPS 4
OVER PRINT
5
Adapt each item of the judgment
conditions to your current state.
(1) Press [] [] to select the setting item, and
press the [ENTER] key.
(2) Press [] [] to select the setting value, and
press the [ENTER] key.
(3) Repeat steps (1) and (2) to set all of the
items.
6
Press the key.
• Begin to check if nozzle recovery at the set
printing conditions can be done.
• When the check is complete, the judgment result
is displayed on the screen.
key.
key.
720 x 720
8
NORMAL
>
1
If nozzle recovery
possible Judgement result
Judgement result
If nozzle recovery
is not possible Judgement result
Judgement result
HEAD1-A
HEAD1-B
HEAD1-C
HEAD1-D
Judgement result
HEAD1-E
HEAD1-F
HEAD1-G
HEAD1-H
HEAD2-A
Head no. and
nozzle line
7
Press
the setting.
Set Whether to Enable NOZZLE
RECOVERY During TEST PRINT
By setting the following to "ON" and registering the nozzle
numbers you want to recover using P.4-13 "Nozzle
Recovery Function", the Nozzle Recovery Function is
enabled when performing test printing (
1
Press (MENU) in LOCAL.
2
Press
"MAINTENANCE", and press the
key.
• Maintenance menu will be displayed.
3
Press to select "NOZZLE
RECOVERY", and press the
4
Press to select "TEST PRINT",
and press the
5
Press to select ON/OFF, and
press the
6
Press
the setting.
Chapter 4 Maintenance
OK
NG
1
0
0
2
1
0
0
0
0
The number of
nozzles that cannot
be recovered.
several times to end
P.2-10).
to select
key.
key.
key.
several times to end
1
2
2
4
5
6
4-15