Connecting Usb2.0 Interface Cable - MIMAKI TS55-1800 Operation Manual

Chapter 1 Before Use
(1) Check the printer screen display.
• On the local screen or the media detection screen, press
the [Enter] key several times to display the information
screen.
• Check that "1000Mbps" is displayed for the LAN status
item.
• If "100Mbps", "10Mbps", or "No connect" is
displayed, you cannot print using the LAN.
• If "100Mbps" or "10Mbps" is displayed, you can
use event mail (
mail function").
INFORMATION
LAN Status
(2) Check the green light of the LAN connector.
• After turning on the machine, the lamp for the LAN
connector will light up as follows.
Color State
Lighting Connected with 1000BASE-T
Green
OFF Connected without 1000BASE-T
Lighting Link-up
Yellow Blinking Receiving data
OFF Link-down
• If the yellow light only lights up, or is blinking, the
status is not 1000Mbps. Check the specifications
of the PC, device, and cables.

Connecting USB2.0 Interface Cable

Connect the PC and this machine with the USB2.0
interface cable.
• Your RIP must be compatible with USB 2.0.
• Contact a RIP maker near your location or our
office when the USB2.0 interface is not attached
to the PC.
1-10
Chapter3 " Setting event
1000Mbps
Condition
USB cable
Notes on USB 2.0 Interface
• Your RIP must be compatible with USB 2.0.
 When two or more TS55 machines are connected
to one personal computer
When two or more TS55 machines are connected to
one personal computer, the personal computer may
not recognize all the TS55 machines normally.
Reconnect the unrecognized TS55 machine to
another USB port, if available, and check to see if it is
recognized.If the TS55 machine is not recognized by
the newly connected USB port, use USB 2.0 repeater
cables available on the market.
 Notes on peripheral devices in USB high speed mode
When a peripheral device (USB memory or USB HDD) to
be operated in USB high speed mode is connected to the
same personal computer that a TS55 machine is
connected to, the USB device may not be recognized.
When TS55 is connected to the personal computer to
which an external HDD is connected via USB, the
speed of data output to TS55 may drop.That can
cause the head unit to stop temporarily at the right or
left end during printing.
 Removing USB memory
If a USB memory module is inserted in the personal
computer to which a TS55 machine is connected, click
"Stop" in the "Safely Remove Hardware" window by
following the instructions given there first and then
remove the module.
Leaving a USB memory module inserted can cause
[ERROR 10 COMMAND ERROR].
Copy the data onto the hard disk before outputting it
for printing.