Pass Density Correct; Setting Pre-Feed; Change Of Setting Type Name - MIMAKI TS55-1800 Operation Manual

Chapter 3 Setup
9
Press the
end the setting.

Pass density correct

If periodic shading differences are noticeable between
passes, it can be reduced by changing this setting.
• A fixed correction is applied in the initial state (Lv 3).
Change this if you can see differences in density in
the initial state.
1
Press
2
Press
and press the
• The setting menu is displayed.
3
Press
4
Press
correct" and press the
5
Press
and press the
• Increase Lv, if thin areas are noticeable. Lower Lv,
if thick areas are noticeable.
• Setting value: Lv0 (no correction) to Lv8
6
Press the
finish.

Setting Pre-feed

The following effects can be expected by feeding back
and forth the media before printing.
• Prevent media from sticking to the various rollers and the
platen of this machine.
• If the wrinkle is shifted to the media, wrinkle reduction can be
expected.
1
Press
2
Press
and press the
• SETUP MENU will be displayed.
3
Press
4
Press
press the
5
Press
lengths.
• Set Value : OFF, 100 to 500 mm
• When [OFF] is set, pre-feed is not executed.
6
Press the
3-10
key several times to
in LOCAL.
(MENU)
to select SETUP 1 to 4,
key.
(>>) twice.
to select "Pass dencity
key.
to select the setting value,
key.
key several times to
in LOCAL.
(MENU)
to select SETUP 1 to 4,
key.
(>>) twice.
to select "Pre-Feed", and
key.
to set the feeding media
key.
7
Press the
end the setting.

Change of setting type name

You can change the name of the setting type.
• The characters that can be used are
alphanumeric characters and symbols.
1
Press
(MENU)
2
Press to select the setting 1 to
4, then press the
• SETUP MENU will be displayed.
3
Change the setting type name.
4
Press the
end the setting.
key several times to
in LOCAL.
(Name) key.
key several times to