MIMAKI TS55-1800 Operation Manual page 108

Chapter5 Troubleshooting
Display
Invalid Operation
Take-up Connect
Invalid Operation
Feeding Connect
Invalid Operation
Take-up Unit None
Invalid Operation
Feeding Unit None
Invalid Operation
Take-up EmerSW On
Invalid Operation
Feeding EmerSW On
Invalid Operation
Take-up Unit Power
Invalid Operation
Feeding Unit Power
Invalid Operation
Take-up Relay Welding
Invalid Operation
Feeding Relay Welding
Invalid Operation
Wiper Move Failure
Message displayed in Local mode
Display
Lower the clamp lever
Please set the media
Temporary Suspension
Check Waste Ink
Replace Waste Ink Tank
!Can'tPrint/Ink IC
Expiration Near M_ _ _ _ _ _ _
5-8
Cause
The function cannot be executed
because the connection between take-
up and feeding is reversed.
The function cannot be executed
because the connection between feed-
ing and take-up is reversed.
The function cannot be executed
because the take-up unit is not con-
nected.
The function cannot be executed
because the feeding unit is not con-
nected.
The function cannot be executed
because the emergency stop switch of
the take-up unit is pushed.
The function cannot be executed
because the emergency stop switch of
the feeding unit is pushed.
The function cannot be executed
because the normal state of the inverter
of the feeding unit cannot be confirmed.
The function cannot be executed
because the normal state of the inverter
of the feeding unit cannot be confirmed.
The function cannot be executed
because there is a possibility that the
relay of the take-up unit is broken.
The function cannot be executed
because there is a possibility that the
relay of the feeding unit is broken.
The function cannot be executed
because the wiper does not operate
properly.
Cause
Clamp lever is raised.
No media is set.
The state where printing is suspended.
The count of the waste ink tank exceeds
the specified amount (80%).
The waste ink tank count exceeded the
specified amount (90%).
It is impossible to print, because the ink
IC chip cannot be used.
The ink has expired (less than 2 months
from expiration).
Measures
• Restart the unit.
If displaying again, contact your local distrib-
utor, our sales office, or service center.
• Execute the operation after releasing the
emergency stop switch of the take-up unit.
• Execute the operation after releasing the
emergency stop switch of the feeding unit.
• Execute the operation after restarting the
unit and confirm that the inverter power sup-
ply of the take-up unit is in the normal state.
• Execute the operation after restarting the
unit and confirm that the inverter power sup-
ply of the feeding unit is in the normal state.
• Restart the unit.
If displaying again, contact your local distrib-
utor, our sales office, or service center.
• Clean the surroundings of the wiper and
restart the device, then execute the function.
Measures
• Lower the clamp lever.
• Set the media.
• Press the remote key to resume printing or
execute data clear, and stop it.
• Check the amount of ink in the waste ink
tank.
• Reset the count after correcting error or
replacing the waste ink tank.
• Check the amount of ink in the waste ink
tank.
• Reset the count after correcting error or
replacing the waste ink tank.
• Replace the ink pack or 10kg ink tank and
ink IC chip.
• Replace the ink pack or 10kg ink tank and
ink IC chip.
(It can be used from the expiration date up to
2 months.)