Reset The Set Value - MIMAKI TS55-1800 Operation Manual

Chapter 4 Maintenance
8
Specify the position of nozzle missing.
• Locate the missing nozzle with the right scale and
the upper scale.
• If you select "Register", without going to print, go
to the nozzle row selection procedure (step 9).
100 90 80 70 60
Approximately 300mm
10
Nozzle missing # 203
9
Press
that needs NOZZLE RECOVERY, and then
press the
SELECT ENTRY NOZZLE
Head No.
HEAD1-A
(H1 to H4)
HEAD1-B
HEAD1-C
HEAD1-D
HEAD1-E
<<
4-14
50 40 30 20 10 0
H1-H M
H1-G Bl
H1-F Y
H1-E K
H1-D K
H1-C Y
H1-B Bl
H1-A M
5 0
A scale of
401
100 nozzles
301
H1-H M
201
101
Nozzle No.
1
to select the Nozzle line
key.
Nozzle
>
line
>
>
>
>
>>
10
Register the Nozzle number that needs
NOZZLE RECOVERY, and press the
key.
(1) Press [][] to select the registration
number from 1 to 10, and press the [ENTER]
key.
(2) Press [][] to register the nozzle number
that needs recovery, and press the [ENTER]
key.
HEAD1-A
No.1
No.2
No.3
No.4
No.5
<<
Registration number: 1~10
11
Press
the setting.
• Up to 10 nozzles can be registered per 1
nozzle line.
• Even if you use this function, time
required for drawing does not change.
• Nozzle recovery is not applied when
printing using the lowest number of
passes.

Reset the Set Value

1
Press (MENU) in LOCAL.
2
Press to select
"MAINTENANCE", and press the
key.
• Maintenance menu will be displayed.
3
Press to select "NOZZLE
RECOVERY", and press the
4
Press to select "RESET", and
press the
5
Press and
(<<) to select the Nozzle line that needs to
be reset, and press the
• A reset confirmation message will be displayed.
6
Press the
7
Press
the setting.
16
128
184
OFF
OFF
>>
Recovery nozzle No. or OFF
several times to end
key.
key.
(PAGE>)
key.
key.
several times to end