MIMAKI TS55-1800 Operation Manual page 107

Illustration
Errors when performing operations
Display
Invalid Operation
!Cover Open
Invalid Operation
!Media Undetected
Invalid Operation
!No Media
Invalid Operation
!Data Remain
Invalid Operation
Check Waste Ink
Invalid Operation
!Ink Error
INK NEAR END
1_ _ _ _ _ _ _
Invalid Operation
!Connect 10kg Supply Unit
Invalid Operation
Take-up LimitDetect
Invalid Operation
Feeding LimitDetect
Invalid Operation
Take-up Wrong
Invalid Operation
Feeding Wrong
Invalid Operation
Take-up CoverOpen
Invalid Operation
Feeding CoverOpen
Display
Please set the ext.heater to the correct
position
Cause
The function cannot be executed
because the cover is open.
Operation cannot be performed because
no media is detected.
Operation cannot be performed because
media is not set.
The function cannot be executed
because the data is being received.
Since the count of the waste ink tank
exceeds the specified amount (80%), the
function cannot be executed.
The function cannot be executed
because an ink error has occurred.
The function cannot be executed
because an ink near-end has occurred.
(Routes with UISS are displayed when
both inks are near-ended.)
10kg The function cannot be executed
because the supply unit is not con-
nected.
The function cannot be executed, since
the upper limit of the take-up tension bar
position is detected.
The function cannot be executed, since
the upper limit of the feeding tension bar
position is detected.
The function cannot be executed, since
the take-up tension bar is not moving
from the lower limit position.
The function cannot be executed, since
the feeding tension bar is not moving
from the lower limit position.
The function cannot be executed
because the cover of take-up unit is
open.
The function cannot be executed
because the cover of feeding unit is
open.
Chapter5 Troubleshooting
Measures
• Check the position of the extension heater.
(make sure to set correct vertical position,
and not set in halfway position)
Measures
• Execute the operation after closing the
cover.
• Execute after media is detected.
• Execute the operation after executing data
clear.
• Replace the waste ink tank, execute the
function after count reset.
• Execute the function after replacing the ink
pack or 10kg ink tank and ink IC chip.
• Restart the unit.
If displaying again, contact your local distrib-
utor, our sales office, or service center.
• Lower the take-up tension bar and then exe-
cute the function.
• Execute the function after lowering the feed-
ing tension bar.
• Execute the function after confirming that the
take-up unit operates properly with the jog
key.
• Execute the function after confirming that the
take-up unit operates properly with the jog
key.
• Execute the operation after closing the cover
of take-up unit.
• Execute the operation after closing the cover
of feeding unit.
1
2
2
2
5
6
5-7