Nozzle Cleaning - MIMAKI TS55-1800 Operation Manual

Chapter 4 Maintenance
4
Press
OUT", and press the
• The carriage moves over the platen.
5
Open the front cover.
6
Clean the Cap Absorber.
• Use a paper towel etc. to wipe off any ink that
sticks to the Cap Absorber.
• You can set the media right or center in this
machine.
Cap Absorber
7
Press the
8
Close the front cover, and press the
key.
• After its initial operation, the machine returns to
step 1.

Nozzle cleaning

1
Press
2
Press
"MAINTENANCE", and press the
key.
• Maintenance menu will be displayed.
3
Press
MAINT.", and press the
4
Press
WASH", and press the
5
Press
want to wash, and press the
4-8
to select "CARRIAGE
key.
Carriage
Cap Cover
key after cleaning.
(MENU) in LOCAL.
to select
to select "STATION
key.
to select "NOZZLE
key.
to select the head you
key.
6
When "WIPER CLEANING" is indicated on
the display, open the front cover and the
right maintenance cover.
7
Clean the wiper, and press the
key.
(1) Open the right maintenance cover and pull it
out by holding the protrusions at both ends of
the wiper.
(2) Clean with a clean stick dipped in cleaning
solution for maintenance.
• Wipe off so that cleaning solution for
maintenance will not remain.
(3) Insert it in the original position by holding the
protrusions at both ends of the wiper.
8
When you have finished cleaning the cap
rubber, close the front cover and press the
key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in cleaning solution for
maintenance.
• Wipe off so that cleaning solution for maintenance
will not remain.
• At this time, the discharge passage is cleaned
automatically.
9
Fill up the cap with cleaning solution for
maintenance.
• When the cleaning liquid cartridge is enabled, the
cap is automatically filled with cleaning solution.
• When the cap is full of cleaning solution, cleaning
solution confirmation instructions are displayed.
• If the front cover is not closed, the cap is
not automatically filled with cleaning
solution. If the front cover is open, make
sure you close it.
Protrusion