Basic Network Settings - Raritan Dominion KX III User Manual

Basic Network Settings

Automatic Reconnection
If your connection to the client fails, an automatic reconnection will be
attempted in most cases. Reconnection is attempted at 30 second
intervals until a successful connection is made.
A message appears when the connection drops with information about
reconnection timing and options to cancel or quit.
Automatic reconnection is not attempted when the connection failure is
due to:
• Configuration error detected. Certificate must be uploaded.
User authentication failed.
•
User authorization failed.
•
• User has been actively disconnected by an administrator.
KX device version not supported by the client.
•
Note: In FIPS mode, the User Station CANNOT connect to any targets on
a KX3 or CC-SG with Security setting TLS 1.2 only.
The User Station's default network configuration is set to Automatic
(DHCP) for both IPv4 and IPv6 settings.
This section describes basic network configuration only. For details, see
Network Connections
To configure basic network settings:
1. Choose Main Menu > System Settings > Network.
2. In the Network Connections dialog, two default network connections
are available for two LAN ports.
Ethernet 2
is for the other.
(on page 181).
Ethernet 1
Chapter 2: Getting Started
is for LAN port 1, and
21