Chapter 7: Using the KVM Client
60
Setting
Noise Filter
Reset to Defaults
3. Click OK to save any changes made. The settings are stored
persistently for the accessed KVM port.
To view connection information:
Click the Info tab in the same dialog.
•
Item
Description
Device Name
The KVM switch's name.
Host / Port
The KVM switch's IP address, and the
TCP/IP port used to access the KVM
switch.
Target Name
The accessed KVM port's name.
Data In / Out
Rate of data received and sent out to
the KVM switch in bytes per second.
Decoded FPS
Number of frames per second that
were received and decoded by the KVM
Client.
Description
This slider controls the noise filter
threshold.
Left: higher threshold.
Right: lower threshold.
Noise Filter
See
(on page 62).
Reset connection properties to the
factory defaults.