Grease Replenishment For Balancer Connection Part - YASKAWA MOTOMAN-MH215 II Instructions Manual

177010-1CD
MH215
II

9.3.1.5 Grease Replenishment for Balancer Connection Part

Fig. 9-8: Balancer Connection Part
Connection 1 Grease inlet
Grease zerk A-PT1/8 (2 grease zerks)
9 Maintenance and Inspection
9.3 Grease Replenishment/Exchange
Exhaust port 2
Hexagon socket head plug PT1/8
Connection 1 Tapered roller bearing
(2 bearings)
1. Remove the hexagon socket head plugs of connection
(Refer to Fig. 9-8 "Balancer Connection Part".)
– Grease type:
– Amount of grease:
2. Inject grease through grease inlets of connection
grease gun.
The exhaust port is used only for air flow.
NOTE
Do not inject excessive grease through the gear grease
inlet.
3. Reinstall the plugs PT1/8 of connection
the plug, apply Three Bond 1206C on the thread part of the plug, then
tighten the plug with a tightening torque of 4.9 N•m (0.5 kgf•m).
Connection 2 Grease inlet
Hexagon socket head plug PT1/8
Exhaust port 1
Hexagon socket head plug PT1/8
Connection 2 Needle bearing
HW1483759
9-23
and
Alvania EP grease 2
5 cc
(10 cc for 1st supply)
and using a
and . Before installing
.
81 of 102