Grease Replenishment/Exchange Procedures; Notes On Grease Replenishment/Exchange Procedures - YASKAWA MOTOMAN-MC2000 II Instructions Manual

9.3

9.3.1 Notes on Grease Replenishment/Exchange Procedures

9 Maintenance and Inspection
9.3

Grease Replenishment/Exchange Procedures

Grease Replenishment/Exchange Procedures
Make sure to follow the instructions listed below at grease replenishment/
exchange. Failure to observe the following instructions may result in
damage to a motor and a speed reducer.
• If grease is injected without removing the plug/screw from
the grease exhaust port, the grease will leak inside a
motor or an oil seal of a speed reducer will come off, which
may result in damage to the motor. Make sure to remove
the plug/screw.
• Do not install a joint, a hose, etc. to a grease exhaust port.
NOTE
Failure to observe this instruction may result in damage to
the motor due to coming off of an oil seal.
• Make sure to use a grease pump to inject grease. Set air
supply pressure to the grease pump at 0.3 MPa or less,
and the grease injection rate at 8 g/s or less.
• Make sure to fill a hose on the grease inlet with grease to
keep air from entering into the speed reducer.
9-7
HW1483028
HW1483028
44/69