Spectracom VelaSync 1232 User Manual page 61

1. Navigate to the
2. In the
3. The
4. In the
5. Click the
6. The established rule appears in the
CHAPTER 2 • VelaSync User's Manual Rev. 3
MANAGEMENT > Network Setup
Actions panel on the left, click on
Network Access Rules
Allow From field, enter a valid IP address. It is not possible, however, to
add direct IP addresses, but instead they must be input as blocks, i.e. you need to
add /32 at the end of an IP address to ensure that only that address is allowed.
Example: 10.2.100.29/32 will allow only 10.2.100.29 access.
I P a d d r e s s n o m e n c l a t u r e :
IPv4—
10.10.0.0/16
mask in prefix form. See the table
subnet mask values.
IPv6— 2001:db8::/48
b8:0:ffff:ffff:ffff:ffff:ffff.
Add button in the
Click the Delete button next to an existing rule, if you want to
2.9 Configuring Network Settings
Access Control.
window displays:
, where is the IP address and
10.10.0.0
"Subnet Mask Values" on page 35
, representing 2001:db8:0:0:0:0:0:0
Action column to add the new rule.
Network Access Rules
screen.
is the subnet
16
for a list of
to 2001:d-
window.
delete it.
49