Configuring Ip Address(Es); Changing The Ip Address Using An Ethernet Connection - Spectracom VelaSync 1232 User Manual

2.7 Configuring IP Address(es)
2. Upon initial login, you will be asked to register your product. Spectracom recom-
mends to register VelaSync, so as to receive software updates and services
notices.
You can also register
register.spectracom.com.
See also
2.7

Configuring IP Address(es)

VelaSync's
192.168.1.1. The DHCP is shipped disabled on this port, but can be reinstated below.
The other Ethernet ports default to DHCP; if connected to a DHCP server via
through
Once you are connected to the Web UI, you can manually adjust the IP addresses for
each ethernet port, and enable or disable DHCP.
2.7.1

Changing the IP address using an Ethernet connection

1. In order to manipulate network configurations, open a web browser, using a PC
that is on the same network as the VelaSync.
2. Navigate to the IP address connected to VelaSync; either the default static
address (ETH0) or the dynamic address assigned by your DHCP.
3. Log onto the Web UI as an administrator. If not yet updated, use the default pass-
word:
4. In the Web
5. In the
to be configured: the
32
Note: For security reasons, please change the default password
immediately; see:
"Product Registration" on
ETH0 network interface port is configured with a unique static IP address:
ETH5, VelaSync will accept a dynamic IP address.
Note: The default login credentials are:
User name = spadmin
Password = admin123
UI HOME screen, select the
Ports panel on the right, click the GEAR button next to the Ethernet port
Edit Ethernet Port Settings
"Managing Passwords" on
your product on the
page 237.
MANAGEMENT
panel will open.
CHAPTER 2 • VelaSync User's Manual Rev. 3
page 180.
Spectracom website
ETH1
menu> Network Setup.
: