Removing/Installing A Hard Disk Drive - Spectracom VelaSync 1232 User Manual

4.3 Hardware Tasks
3. To remove the power supply module from the VelaSync unit, push the release
tab to the side, and then pull the module straight out.
Figure 4-1:
4. Replace the failed power supply module with a replacement unit.
Simply push the new power supply module into the empty bay until you hear a
click.
5. Plug the AC power cord back into the new power supply.
4.3.2

Removing/Installing a Hard Disk Drive

Since the SATA Hard Disk Drives (HDDs) are hot-swappable, and they are RAID con-
figured, either of the two drives can be removed from the front of the VelaSync chassis,
without the need to open the chassis, or shut down VelaSync.
164
Power supply removal
Note: Only use the approved type of power supply, for more
information, see
Note: For additional information on the power supplies, see
https://www.supermicro.com/manuals/superserver/1U/MNL-1771.pdf
Chapter 2 on page 2-1.
Caution: Allow the hard disk drives to cool before touching.
"Maintenance and Service" on
CHAPTER 4 • VelaSync User's Manual Rev. 3
page 237.
,