Establishing A Network Connection - Spectracom VelaSync 1232 User Manual

2.5 Basic Connections Setup
2. Plug in power to both power supplies (items 13 & 14
on the previous
As soon as at least one of the two power supplies has been connected to the
mains voltage, you may hear
However, note that the unit is not running yet (check the front indicator lamps:
they will remain dark).
3. Switch the unit on by pressing the ON/OFF button on the front panel. Wait for
the device to boot up.
Figure 2-5:
4. Once the boot process is completed, only the green POWER status LED should
be lit.
2.5.3

Establishing a Network Connection

5. You can chose to communicate with your VelaSync upon setup in one of three
ways:
30
DANGER! This product relies on the building's installation for short-cir-
cuit (overcurrent) protection. Ensure that the protective device is rated
not greater than: 250 V, 20 A.
page)..
Note: If only one power supply is running, and the other one is
inserted all the way, but not plugged in, or defective, VelaSync
will emit a long BEEP, so as to alert you of a problem with the
backup power.
ON/OFF button
"Basic Connections Setup"
fan noise from inside the VelaSync housing.
CHAPTER 2 • VelaSync User's Manual Rev. 3