Ntp Reference Configuration; Ntp Servers And Peers - Spectracom VelaSync 1232 User Manual

2.10.7 NTP Reference Configuration
VelaSync's NTP Service needs to be setup such that it utilizes the time source ("input
reference") you want it to use. There are two options for an NTP Server to derive its
time from:
a. The NTP Service uses VelaSync's System Time System Time is the time derived
2.10.8 NTP Servers and Peers
VelaSync can be configured to receive time from one or more available NTP Servers
(VelaSyncs or different models). This allows for NTP Servers on a timing network to be
configured as potential (fallback) input time references for VelaSync System Time syn-
chronization. In the event that a current reference becomes unavailable, VelaSync can
fallback to the other NTP Servers available on the network.
A group of NTP servers at the same Stratum level (Stratum 1 time servers, for
example) are considered as
NTP Servers at the same Stratum level
If VelaSync is configured to obtain time from other NTP Servers at the same Stratum
level (i.e., NTP Peers) but is currently using a different input reference as its selected ref-
erence, VelaSync will report to the network (via the NTP time stamps) that it is a
Stratum 1
server(s) become unavailable, VelaSync will then drop to a
System Time being derived from the NTP time packets being received from the other
NTP Peers.
Holdover
If VelaSync is synchronized to another NTP Server or reference, and that server or ref-
erence subsequently loses sync or becomes unavailable (with no other higher priority
input references being present and valid), VelaSync will then go into the
CHAPTER 2 • VelaSync User's Manual Rev. 3
Note: When the Timescale is set to "GPS", the
Offset
between UTC and GPS is 18 seconds.
from the internal Timing System. The Timing System is the time server's central
time processing engine. It consumes and processes time and 1PPS obtained from
an external input reference e.g., typically GNSS., i.e. typically the GNSS reference
(or IRIG, ASCII data input, etc.), and distributes that time over the NTP network.
This is called Stratum 1 Operation, because VelaSync will be the Stratum 1 (or
primary) server. This is the most common configuration.
NTP Peers
time server. Should, however, all input references except the other NTP
must be set correctly. As of 26-Oct-2018, the offset
to each other.
2.10 Configuring NTP
GPS to UTC
Stratum 2 time server (with
Holdover mode.
75