Irig Standards And Specifications; About The Irig Output Resolution - Spectracom VelaSync 1232 User Manual

Command
slaacset
stateset
status
syncstate
sysupgrade
testevent
tfomget
timeget
timeset
unrestrict
version
yearget
yearset
zeroize
5.3

IRIG Standards and Specifications

5.3.1

About the IRIG Output Resolution

The IRIG output signals are generated from VelaSync's System Time, which can be
synced to one or more external input references (such as GPS, IRIG, PTP, etc). The
accuracy of the System time to true UTC time is dependent upon what the selected
external reference is (with GPS typically being the most accurate reference for the sys-
tem to sync with).
IRIG AM synchronization of a device to its IRIG source is typically measured in the tens
of microseconds, while synchronization using a IRIG DCLS signal can typically provide
VelaSync User's Manual
Used to enable or disable SLAAC
Enable or disable an entry in the reference priority table. index = 0...15. state
= 0 (disable), 1 (enable)
Displays information about the oscillator disciplining
Display timing system synchronization state
Performs system upgrade using the update bundle provided
Generates SNMP events in the enterprise MIB
Displays current estimated system time error (TFOM – Time Figure of
Merit)
Displays current system time (time is displayed in the configured timescale
– See command to retrieve the configured timescale)
scaleget
Used to manually set the current time (hours, minutes in seconds); time is
entered based on the configured timescale – See
retrieve the configured timescale
Used for clearing access control restrictions to VelaSync
Displays the installed main VelaSync and timing system software versions
Displays the current year
Used to set the current year
Applicable to SAASM-equipped VelaSync units only
Description
scaleget
APPENDIX
command to
221