Cli Commands - Spectracom VelaSync 1232 User Manual

4. Using the Terminal window, you can now submit commands.
5.2.2 CLI Commands
VelaSync features a suite of command-line interface (CLI) commands that can be used
to configure parameters and retrieve status information or log files via a remote con-
nection, using the telnet or ssh (if enabled) protocol.
This section includes a list of some of the supported commands.
Notes:
a. The command "helpcli" will provide a list of all available commands and their syn-
tax (Note: Typing "help" will output bash shell help only and will not provide useful
information).
b. You can scroll up or scroll down through the output by using the Page Up/Page
down keys, or the arrow keys.
c. Type "q" (lower-case) to quit.
d. Pressing the up/down keys scrolls through previously typed commands.
e. Commands need to be typed in all lower-case letters.
f. Where eth0 is the base network port and eth1 (and higher) are used with the
optional Gigabit Ethernet module for multiple network interfaces.
g. User accounts with "user" group permissions can perform "get" commands but
cannot perform any "set" commands or change/reset passwords. Only user
accounts with "admin" group permissions can perform "set" commands or
change/reset password. Refer to
page 177
Command
clean
cleanhalt
clearlogs
clearstats
dateget
dateset
VelaSync User's Manual
for user account setup information.
Restores VelaSync configuration to factory defaults and reboots
Restores VelaSync configuration to factory defaults and halts
Clears all logs
Clears all statistical data (NTP, and oscillator/disciplining)
Displays current date (for example, 15 APR 2015)
Used to set the current date
"Adding/Deleting/Changing User Accounts" on
Description
APPENDIX
217