Spectracom VelaSync 1232 User Manual page 149

Table of Contents

Advertisement

Relocating VelaSync
The
moved, and it did not self-initiate a new survey automatically. Note that neglecting to
delete the old position data and discover the new position data will cause VelaSync not
to go into synchronization state.
Sanitization
The
(ensuring that no trace of position data remains on the unit).
Deleting the GNSS position
To delete the GNSS position:
  1. Disconnect the GNSS antenna from the VelaSync unit (this is required
  2. Navigate to
  3. Click on the GEAR button next to the GNSS Reference (typically, there is only one
  4. VelaSync will initiate a GNSS self survey.
CHAPTER 3 • VelaSync User's Manual Rev. 3
Note:
A
self survey
Delete Position
command may need to be used if a VelaSync system is physically
Delete Position
command must also be used when
sanitizing
the unit).
Interfaces > References: GNSS
reference, numbered "0"). The
Locate the
Delete Position
Note:
In
Mobile Receiver Mode
ition and start the GNSS survey. This feature is only available in
ard Mode
and in
Single Satellite
survey may take up to 24 hours.
will take at least 2000 seconds (33 minutes).
Reference. 
GNSS 0
window will open:
box, check it, and click Submit.
it is NOT possible to delete the pos-
Mode. In Single Satellite Mode a GNSS
3.3  Managing References
sanitizing
a VelaSync unit
only when
Stand-
137

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VelaSync 1232 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Velasync 1225

Table of Contents