Tlv Impact On System Parameter Values - Avaya J129 Installing And Administering

Category
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
Avaya Proprietary
Avaya Proprietary
Avaya Proprietary
Avaya Proprietary
Basic Mandatory

TLV impact on system parameter values

System parameter
name
PHY2VLAN
L2QVLAN and L2Q
November 2017 Installing and Administering Avaya J129 IP Phone in third-party call control setup
TLV Name (Type) TLV Info String (Value)
Inventory – Firmware version.
Firmware Revision
Inventory – Software version or filename.
Software Revision
Inventory – Serial Device serial number.
Number
Inventory – Avaya.
Manufacturer Name
Inventory – Model MODEL with the final Dxxx characters removed.
Name
Call Server IP Call Server IP Address. Subtype = 3.
address
IP Phone Phone IP address, Phone Address Mask, Gateway IP Address.
addresses Subtype = 4.
File Server File Server IP Address. Subtype = 6.
802.1Q Framing 802.1Q Framing = 1 if tagging or 2 if not.
End-of-LLDPDU Not applicable.
TLV name Impact
IEEE 802.1 Port The value of the PHY2VLAN parameter on the phone is
VLAN ID configured from the value of the Port VLAN identifier in the TLV.
IEEE 802.1 VLAN The value is changed to the TLV VLAN Identifier. L2Q is set to 1
Name (ON).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the parameters
L2Q or L2QVLAN.
VLAN Name TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The current value of L2QVLAN was set by a TIA LLDP MED
Network Policy TLV.
• The VLAN name in the TLV does not contain the substring
"voice" in lower-case, upper-case or mixed-case ASCII
characters anywhere in the VLAN name.
Comments on this document? infodev@avaya.com
Configuration through LLDP
Table continues...
27