Resetting System Values - Avaya J100 Series Installing And Administering

Phone administration
Procedure
1. Press Main Menu > Administration.
2. In the Access code field, enter the admin menu password.
3. Press Enter.
4. Select 802.1X.
The phone displays the following settings:
• Supplicant
• Pass-thru mode
5. Select the setting that you want to change.
6. Press the Change softkey or the Left and Right Arrow keys to cycle through the following
settings:
• For the Pass-thru mode:
- On: If DOT1X = 0
- On & proxy logoff: If DOT1X = 1
- Off: If DOT1X = 2
• For the Supplicant:
- Disabled: If DOT1XSTAT = 0
- Unicast: If DOT1XSTAT = 1
- Multicast: If DOT1XSTAT = 2
7. Press Save.
When you change the 802.1X data, the phone restarts after you exit the administration
menu.

Resetting system values

About this task
Use this procedure to reset all system initialization values to the application software default
values.
Caution:
This procedure erases all static information, without any possibility of recovering the data.
Procedure
1. Press Admin menu > Administration.
August 2018 Installing and Administering Avaya J100 series IP Phones in third-party call control
setup
Comments on this document? infodev@avaya.com
102