Figure 27. Installing the intrusion switch
Next steps
1
Install the air shroud.
2
Follow the procedure that is listed in
Drives
Removing a drive blank
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the front bezel.
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Press the release tab, and slide the drive blank out.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
55