Table of Contents
Advertisement
2. If applicable, install the system into the rack.
For more information, see the Rail Installation Guide at www.dell.com/poweredgemanuals.
3. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
Recommended tools
You need the following tools to perform the removal and installation procedures:
•
Key to the bezel lock
The key is required only if your system includes a bezel.
•
Phillips #1 screwdriver
•
Phillips #2 screwdriver
•
Torx #T20 screwdriver
•
5mm hex nut screwdriver
•
Plastic scribe
•
1/4 inch flat blade screwdriver
•
Wrist grounding strap connected to the ground
•
ESD mat
Optional front bezel
NOTE:
LCD panel is optional on the front bezel. If the front bezel has an LCD panel, see
Removing the front bezel
The procedure to remove the front bezel with and without the LCD panel is the same.
Prerequisites
1. Follow the safety guidelines listed in the
2. Keep the bezel key handy.
NOTE:
The bezel key is part of the LCD bezel package.
Steps
1. Unlock the bezel.
2. Press the release button, and disengage the left end of the bezel.
3. Unhook the right end, and remove the bezel.
Safety
instructions.
LCD panel
Installing and removing system components
section.
41
Advertisement
Table of Contents
