Configuring Rip Authentication - Cisco Catalyst 9500 series Configuration Manual

Configuring RIP Authentication

Step 13
Step 14
Step 15
Configuring RIP Authentication
RIP Version 1 does not support authentication. If you are sending and receiving RIP Version 2 packets, you
can enable RIP authentication on an interface. The key chain specifies the set of keys that can be used on the
interface. If a key chain is not configured, no authentication is performed, not even the default.
The Device supports two modes of authentication on interfaces for which RIP authentication is enabled: plain
text and MD5. The default is plain text.
Procedure
Step 1
Step 2
Routing Configuration Guide, Cisco IOS XE Everest 16.6.x (Catalyst 9500 Switches)
84
Command or Action
end
Example:
Device(config)# end
show ip protocols
Example:
Device# show ip protocols
copy running-config
startup-config
Example:
Device# copy running-config
startup-config
Command or Action
enable
Example:
Device> enable
configure terminal
Example:
Device# configure terminal
Purpose
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Purpose
Enables privileged EXEC mode. Enter your
password if prompted.
Enters the global configuration mode.
Configuring IP Unicast Routing