Assigning A Password - Eaton easyE4 series Manual

INTERFACE Protects against access to the Ethernet interface of this device.
Data exchange via the net is not affected.
DELETE When this function is not activated, the question "DELETE PROG?" will
FUNCTION appear if the password entry is entered incorrectly four times. This
question does not appear if you protect the this area. However, it is no
longer possible to make changes in protected areas if you forget the
password.
At least one of the following areas must be protected: Pro-
gram, Parameters, Clock, Operating Mode, or Memory Card.
If you do not select any of these areas, "Program" will be selec-
ted automatically.
The PROGRAM area will be selected by default when using the
device's factory settings.

Assigning a password

Go to the main menu.
Go to SYSTEM OPTIONS\SECURITY.
Select the PASSWORD menu option.
Table 78: System-Option-
s\Security
PASSWORD
RANGE
You can use any numbers or letters for the six-character password. Special characters
and umlauts are not permitted.
PASSWORD: 0 X X X X X
A B C D E F G H I J K L M
N O P Q R S T U V W X Y Z
1 2 3 4 5 6 7 8 9 0
Figure 227: Pass-
word assignment
The first password character will flash.
Select the first letter or number for the password.
Confirm the entry with the OK pushbutton.
Repeat these steps for the remaining characters in the password.
You can cancel at any time with the ESC button.
easyE4 11/18 MN050009 EN www.eaton.com
7.14 Security – password protection
Take into account the restricting effect of a protected
interface if you have to reset the easyE4 device.
7. System settings
477