Status Display On The Control Relays With Display And Keypad - Eaton easyE4 series Manual

3.3.4 Status display on easyE4 control relays with display and keypad
After being switched on, the easyE4 base device will start with the status display after
the boot logo.
The status display has six lines, with each one containing 16 characters.
Press the Alt button to switch between displays.
The first time you press ALT, the time will be replaced by the date.
Pressing the ALT button again will switch to display 2
Status indicator 1
1
I 1 2 . . .
2
R E
3
CO D h h : m
4
5 q 1 2 3 .
6 Device name
IP Address
Figure 49: Start displays for easyE4 base device in English
Status indicator 1
Line 1 The Ethernet status for the base device without LED indicators will be shown for diagnostic purposes
EOF
ECN
EOK
ENW
ENM
EER
Line 2 Settings in current program
RE
I
NT
DC
P
Line 3 Current device setting
WD
hh:mm
1xALT DD-MM-YYY
ST
Line 4
q
RUN/STOP
easyE4 11/18 MN050009 EN www.eaton.com
6 8 . . . E O K
I N T 1 D C P -
m S T
A A
S T O P
The Ethernet port is not enabled;
no Ethernet cable connected; supply voltage off
The port is not enabled; the easyE4 device does not have an IP address
Ethernet cable connected
There is an Ethernet IP address, but the NET has not been configured
NET data flow working; all NET stations working
NET data flow working; one or more NET stations missing
Ethernet conflict or error, e.g.: duplicate IP address, address collision
Retention active
Debounce active
NET stations with NET ID (1 this case)
Used to display the type of power used by the base device (AC or DC)
P Buttons inactive (-) or active (+)
Weekday
Device time
Displays the device date with the configured format
Configured startup behavior for the device;
nothing displayed – automatic starting is possible
Outputs; the number will be shown during activity (1, 2, 3, etc.)
Current device operating mode
3. Commissioning
Status indicator 2
1 2 3 4 5 6 7 8
I D 1 - 8 :
I D 9 - 16 :
I D 17 - 24 :
3.3 Switch on
S T O P
81