System Settings - Ethernet; Remote Run - Eaton easyE4 series Manual

7. System settings
7.6 Ethernet
7.6 Ethernet
464

Remote RUN

If this field is enabled, the NET stations of a group with NET-IDs 02 through 08 will take
their current RUN or STOP operating mode from the NET station with NET-ID 1.
See also
→ Section "Setting up a NET", page 537
This submenu can be used to configure the addresses for the easyE4 device.
The other station must also be configured accordingly in order for it to be possible to
establish a connection.
The last line on the status display will indicate whether there is an active connection.
New easyE4 base devices will come with the Auto IP setting configured by default. In
order to configure the settings differently on the EASY-E4-...-12...C1, use the menu struc-
ture and go to System Options\Ethernet
The submenu is only available in English.
Table 70: Ethernet configuration on device
Table 71: Main menu
STOP ✓ RUN
PARAMETERS
SET CLOCK
CARD
INFORMATION
SYSTEM-OPT.
PROGRAM
Use the cursor buttons to enter the device's
IP address.
Select the network setting you want.
See also
→ Section "Establishing an Ethernet connection", page 532
easyE4 11/18 MN050009 EN www.eaton.com
Table 72: System options
SECURITY
SYSTEM
MENU LANGUAGE
DELETE PROGRAM
NET
ETHERNET
Table 73: System option-
s\Ethernet
ADDRESS MODE
IP ADDRESS
SUBNET MASK
GATEWAY ADDRESS
DNS SERVER
Table 74: System Option-
s\Ethernet\IP Address
IP ADDRESS
000.000.000.000
Table 75: System Option-
s\Ethernet\Address mode
AUTO IP ✓
DHCP
STATIC IP