Eaton easyE4 series Manual page 348

6. Function blocks
6.1 Manufacturer function blocks
344
Description
the previously set AC output changes
from a state of 1 back to 0.
The output will remain with a state of
1 until a new transmit job is activ-
ated.
Assigning operands
You can assign the following operands to the function block outputs that are numeric
outputs:
Assigning operands
Constant
Markers: MB, MD, MW
Analog inputs IA
Analog output QA
Numeric output from another QV FB
You can assign the following operands to the function block outputs that are bit outputs:
Assigning operands
Constant 0, constant 1
M – Markers
SN - Output bit via NET (send)
N - Network marker bit
nN - NET station n marker
LE - Output backlight
Q - Bit output from another FB
Parameter set
Function block release by
EN is necessary
No edge evaluation of T bit
input
easyE4 11/18 MN050009 EN www.eaton.com
Note
Outputs
x
x
x
x
x
Bit outputs
x
x
x
x
x
x
x
Description
If this checkbox is enabled, the state
of function block input EN will be
evaluated. If the checkbox is dis-
abled instead, the function block will
be enabled and function block input
EN will not do anything.
When this checkbox is enabled, the
data will be transmitted to the NET
based on cycle times. It will be
transmitted every nth cycle, where n
can be defined in the parameters for
the function block.
If the checkbox is disabled, manual
transmission triggering with an edge
Note
This parameter ensures that
when existing programs are
copied, the functionality of the
function blocks that are carried
over will be retained. The para-
meter will be automatically set
to 0 or 1 depending on the func-
tion block.