Eaton easyE4 series Manual page 355

Description
1: The most recent send job is still in progress.
0: The most recent send job has been completed.
Assigning operands
You can assign the following operands to the function block outputs that are numeric
outputs:
Assigning operands
Constant
Markers: MB, MD, MW
Analog inputs IA
Analog output QA
Numeric output from another QV FB
You can assign the following operands to the function block outputs that are bit outputs:
Assigning operands
Constant 0, constant 1
M – Markers
SN - Output bit via NET (send)
N - Network marker bit
nN - NET station n marker
LE - Output backlight
Q - Bit output from another FB
Parameter set
Parameter set
Function block release
by EN is necessary
Web server active as
long as there is a state of 1
at input EN
Parameter display
+ Call enabled
Type of information trans-
mission
Recipient assignment
easyE4 11/18 MN050009 EN www.eaton.com
Outputs
x
x
x
x
x
Bit outputs
x
x
x
x
x
x
x
Description
If this checkbox is enabled, the state of
function block input EN will be eval-
uated. If the checkbox is disabled
instead, the function block will be
enabled and function block input EN
will not do anything.
The web server will be selectively
turned on and off based on AL_EN.
In order for this to work, the web server
must not be permanently enabled; go to
→ "Webserver tab", page 1.
Function block parameters and con-
stants can be edited on the device.
E-Mail; there are no other options as of
this writing
Used to select one of the three possible
recipient groups. Each recipient group
6. Function blocks
6.1 Manufacturer function blocks
Note
Note
This parameter ensures that when
existing programs are copied, the
functionality of the function blocks
that are carried over will be
retained. The parameter will be
automatically set to 0 or 1 depend-
ing on the function block.
Turning off the web server saves
processing time
Each recipient group needs to be
set up in the hardware con-
351