Eaton easyE4 series Manual page 319

Parameter set
Parameter set
Function block release by
EN is necessary
Parameter display
+ Call enabled
Simulation possible
Other
Retention
The function block does not recognize retentive data.
Example of a configuration for a BT block transfer function block on the device dis-
play
When using the function block in the circuit diagram for the first time, use OK to auto-
matically enter the display of function blocks on the device display, as shown in the fol-
lowing figure.
BT07 INI +
>I1
>I2
> NO
Figure 164: Parameters on the display
Enter the function block settings here. The display contains the following elements:
BT07 block transfer Function block: block transfer, number 07
INI Operating mode: INI - Initialize
+ Parameter set can be called via the PARAMETERS menu
>I1 Start address of source range or initialization markers (MB,MW,MD)
>I2 Start address destination range
> NO Number of elements to be written in bytes per range, number: 1...383
Example of a block transfer function block when using the EDP programming lan-
guage
The trigger coil is connected to a device input.
I 05-----------------------------Ä BT07T_
Figure 165: Wiring the trigger coil
easyE4 11/18 MN050009 EN www.eaton.com
6.1 Manufacturer function blocks
Description
If this checkbox is enabled, the state
of function block input EN will be
evaluated. If the checkbox is dis-
abled instead, the function block will
be enabled and function block input
EN will not do anything.
Function block parameters and con-
stants can be edited on the device.
6. Function blocks
Note
This parameter ensures that
when existing programs are
copied, the functionality of the
function blocks that are carried
over will be retained. The para-
meter will be automatically set
to 0 or 1 depending on the func-
tion block.
315