Power Flow Display With Zoom Function - Eaton easyE4 series Manual

4. Operation
4.5 Your first EDP program
112

Power flow display with Zoom function

A reduced display of the circuit diagram is possible for a better overview. To do this, fol-
low the steps below:
Change to the circuit diagram display and press the ALT button.
The circuit diagram display is reduced.
Press pushbutton S1.
Figure 62: Current flow display with zoom
Power flow display in Zoom function: Input
up
Contact closed, coil is triggered.
Contact opened, coil not triggered.
Press pushbutton S2, that has been connected as a break contact.
The power flow is interrupted and relay Q1 drops out.
Figure 63: Current flow display with zoom
Use the
Press the cursor button
The cursor moves to the second contact.
Press the ALT button. The zoom function will be turned off and the display will switch to
the display status with contact and/or coil designations.
Power flow display: Input I01 is closed, input I02 is open, relay Q1 has dropped out.
easyE4 11/18 MN050009 EN www.eaton.com
I001
cursor buttons to move from contact to contact or coil.
.
and are closed, relay Q1 picked
I002