Assigning I/O Parameters To Cyclic Modules - Eaton Power Xpert C445 User Manual

Chapter 9—C445 Logic Engine and Expansion I/O

Assigning I/O parameters to Cyclic Modules

To assign Input parameters, select the cyclic module to reveal the input assignments
for each word as shown below for Cyclic Module 16 (16 input words). Below is an
example. All parameters are available and may be assigned to each input word.
To assign Output parameters, select the C445 to reveal the output assignments which
are at the end of the configuration file parameters as shown below. These are assigned
different than the input parameters. For Output assignments, select cyclic module
words for each available parameter, including digital and analog output data. Below is an
example for the 8 output words for Cyclic Module 16. All parameters are available and
may be assigned to each output word for the cyclic modules. Rules concerning the
Fieldbus Motor Control word and Motor Control bit assignments is discussed earlier in
this section.
Power Xpert C445 Global Motor Management Relay MN042003EN—January 2019 www.eaton.com 203