Eaton easyE4 series Manual page 245

Assigning operands
You can assign the following operands to the function block outputs that are numeric
outputs:
Assigning operands
Constant
Markers: MB, MD, MW
Analog inputs IA
Analog output QA
Numeric output from another QV FB
You can assign the following operands to the function block outputs that are bit outputs:
Assigning operands
Constant 0, constant 1
M – Markers
SN - Output bit via NET (send)
N - Network marker bit
nN - NET station n marker
LE - Output backlight
Q - Bit output from another FB
Parameter set
Parameter set Description
If this checkbox is enabled, the state of
Function block
function block input EN will be eval-
release by EN is
uated. If the checkbox is disabled
necessary
instead, the function block will be
enabled and function block input EN will
not do anything.
Parameter display Function block parameters and constants
+ Call enabled
can be edited on the device.
Simulation pos-
sible
easyE4 11/18 MN050009 EN www.eaton.com
6.1 Manufacturer function blocks
Outputs
x
x
x
x
x
Bit outputs
x
x
x
x
x
x
x
Note
This parameter ensures that when exist-
ing programs are copied, the func-
tionality of the function blocks that are
carried over will be retained. The para-
meter will be automatically set to 0 or 1
depending on the function block.
6. Function blocks
241