Eaton easyE4 series Manual page 202

6. Function blocks
6.1 Manufacturer function blocks
198
Device parameter
X
â
?X
#
ü
Ü
#
?
#
Function block outputs
Description
(Bit)
Q1 Switching contact
(DWord)
QV Elapsed actual time in RUN mode
Parameter set
Configuration/time range
S
M : S
H : M
Parameter display
+ Call enabled
Simulation possible
easyE4 11/18 MN050009 EN www.eaton.com
Control mode easySoft 7
On/off delayed
On/off-delayed with random time
Single pulse
Flashing
Time values:
S1=Pulse time,
S2= Pause time;
Off-delayed with retriggering
Off-delayed with retriggering and
random time
Note
Integer value range:
0 to max. 99990 in time range: seconds;
milliseconds; hours
depending on configured time range.
Description
Seconds:Milliseconds
Configurable as a constant:
00.005 to 999.995 (s.ms)
Minutes:Seconds
Configurable as a constant:
00:01 to 99:59 (min:s)
Hours:Minutes
Configurable as a constant:
00:01 to 99:59 (h:min)
Function block parameters and con-
stants can be edited on the device.
Note
There are two time setpoints to be
configured.
With random time, 2 time setpoints
Normalizes input signals of dif-
ferent pulse lengths to a fixed pulse
length at the switch contact of the
timing relay.
Time values
Two time reference values need to
be configured.
I1=Pulse time,
I2= Pause time;
Synchronous flashing: I1 = I2
Mark-to-space ratio = 1:1
Asynchronous flashing: I1 ≠ I2
Mark-to-space ratio ≠ 1:1
Retriggerable reference value
Retriggerable reference value
Note
Resolution: 5 ms
Resolution: 1 s
Resolution: 1 min