Diagnostics Messages Of The Operating System - Eaton easyE4 series Manual

10. Diagnostics messages of the operating system

Diagnostic operands are used in order to obtain information regarding operating states
in the program (this functionality can only be used when the base device is in RUN
mode). If the described event has occurred, the operands will have a state of 1.
Operand Event
ID01
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID02
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID03
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID04
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID05
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID06
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID07
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID08
There are more than two devices in this NET group and the NET is active. The following NET sta-
tion is not present:
ID09 The DCF77 radio time signal has been enabled in the program. A radio signal is not being detected
at the selected input.
ID10 This diagnostic bit is set if one of the following time synchronization operations could not be com-
pleted successfully:
"Synchronize clock via NET"
l
"SNTP synchronisation"
l
Date and time
l
DCF77 radio clock
l
Using the SC function block will not result in this error message or in it being cleared.
ID11 If the device cannot communicate via Ethernet.
ID12 Arithmetic blocks have their own error output that is used to signal whether there is a numeric under-
flow/overflow, e.g., as a result of attempting to divide by zero. When using the ST programming
language, this diagnostic operand will additionally be set if such an error occurs.
ID13 If the base device is being operated with one or more expansion devices, this diagnostic operand
will indicate whether required devices are disconnected from the easyConnect bus or are not being
detected, e.g., in the event of a power failure on an expansion device.
ID14 Transistor outputs in the base device are experiencing an overload or a short circuit; the outputs will
be switched off and then checked again after 30 seconds.
ID15 –
ID16 –
ID17 –
ID18 –
ID19 There is an interrupt overload. One or more interrupt function blocks are being used, and the interrupt
easyE4 11/18 MN050009 EN www.eaton.com
10. Diagnostics messages of the operating system
1
2
3
4
5
6
7
8
517